(343/364) 2023-12-04_14-31-02.jpg
I put some threads on the oil can spout ( focus never holds still)..
342: There is some backlash in the adjustment - but I think that is par for the course. Stuff out of China is still cheap - but quality seems to be going up.
341: Actually well done - the dovetail has a flexture - it is tightened with 3 cone head grub-screws that press on small ball bearings.
340: Tool holder to boring head - needs a trim for the shoulder.
339: Tool holder to boring head - needs a trim for the shoulder.
338: 2023-11-26_21-06-23.jpg
337: Deburred and adjustable index point for the drill sharpener.
336: Tabs worked - narly burs..
335: 2023-11-26_20-39-53.jpg
334: Cutting the index plate
333: Re did the lapping plate magnet project with bigger magnets.
344: The aluminum tip is no longer smooth and round - thus does not seal the oil-ball oilers..
345: Side project - this tilt table was made for 12mm - just a bit too small for 1/2" clamp hardware.
346: The same for the top - widening the slots for 1/2" hardware - (12mm will still work)..
347: Found a T-slot cutter in some HSS cutters I picked up years ago on E-bay..
348: Lots of cast Iron swarf..
349: Another side job - putting in some threaded holes so this can sharpen chisels on the Dekel style D-bit grinder..
350: Re did the lapping plate magnet project with bigger magnets.
351: Re did the lapping plate magnet project with bigger magnets.
352: Tiny Plasma cutter fits with room to spare on the bottom of the welding cart.
353: Measuring to spindle height ..
