(347/364) 2023-12-04_20-34-33.jpg

Found a T-slot cutter in some HSS cutters I picked up years ago on E-bay..

346: The same for the top - widening the slots for 1/2" hardware - (12mm will still work)..
345: Side project - this tilt table was made for 12mm - just a bit too small for 1/2" clamp hardware.
344: The aluminum tip is no longer smooth and round - thus does not seal the oil-ball oilers..
343: I put some threads on the oil can spout ( focus never holds still)..
342: There is some backlash in the adjustment - but I think that is par for the course. Stuff out of China is still cheap - but quality seems to be going up.
341: Actually well done - the dovetail has a flexture - it is tightened with 3 cone head grub-screws that press on small ball bearings.
340: Tool holder to boring head - needs a trim for the shoulder.
339: Tool holder to boring head - needs a trim for the shoulder.
338: 2023-11-26_21-06-23.jpg
337: Deburred and adjustable index point for the drill sharpener.