(15/364) 2023-01-11_18-02-09.jpg
Alsmot finished - just need to cut a flat on it.
14: Blue on the entire taper - not easy. I can't trust the flats on the lathe.
13: Fixed this only to realize I can't find the crystal
12: Fixed this only to realize I can't find the crystal
11: Tim's new shop progress
10: Water heater desinged by sadists - no clearance - had to spend 50min disassembling to change out the anode.
9: Need better tap holders and this tap is not so sharp.
8: don't like the finish, but it did blue up OK
7: Turning taper, but nasty finish - I think I really need to be able to adjust the height.
6: Very fiddly setup to set the compound.
5: Inks up OK
16: Nice snug fit in the tool holder - figured out the finish problem at the end of my efforts.
17: Taper grabs the wheel arbor.
18: Starrett 91 Single sided pin - very hard to remove
19: Replaced with some copper wire. Needed to dissasemble to regrind the seat that holds the tap.
20: 2023-01-12_20-03-01.jpg
21: 2023-01-13_13-01-55.jpg
22: 2023-01-13_13-26-22.jpg
23: AC4 diamond powder (Venev diamonds) - grain size from 2500 to 40 microns.-- 80-100um or 140-170grit
24: This did not work well - ended up chipping the disk
25: This worked much better
