(21/364) 2023-01-13_13-01-55.jpg
20: 2023-01-12_20-03-01.jpg
19: Replaced with some copper wire. Needed to dissasemble to regrind the seat that holds the tap.
18: Starrett 91 Single sided pin - very hard to remove
17: Taper grabs the wheel arbor.
16: Nice snug fit in the tool holder - figured out the finish problem at the end of my efforts.
15: Alsmot finished - just need to cut a flat on it.
14: Blue on the entire taper - not easy. I can't trust the flats on the lathe.
13: Fixed this only to realize I can't find the crystal
12: Fixed this only to realize I can't find the crystal
11: Tim's new shop progress
22: 2023-01-13_13-26-22.jpg
23: AC4 diamond powder (Venev diamonds) - grain size from 2500 to 40 microns.-- 80-100um or 140-170grit
24: This did not work well - ended up chipping the disk
25: This worked much better
26: Material shelf needs to be reoganized.
27: Truing up a grinding cup using the tapered arbor I made.
28: Fixing my micrometer that I dropped . Reminder - never drop instruments!
29: They don't use sink hangers anymore. They apply silicone caulk/glue and then twist the wires to clamp it into place.
30: Before restoration - A Herman Schmidt/Murkens style Suface-plate-indicator-stand.
31: 2023-01-18_00-52-40.jpeg
