(5/364) 2023-01-01_19-05-35.jpg

Inks up OK

4: Trimming the MT3
3: +/- 10um run out
2: Glasses with pocket clip
1: Clinton Street Bay window apartment

6: Very fiddly setup to set the compound.
7: Turning taper, but nasty finish - I think I really need to be able to adjust the height.
8: don't like the finish, but it did blue up OK
9: Need better tap holders and this tap is not so sharp.
10: Water heater desinged by sadists - no clearance - had to spend 50min disassembling to change out the anode.
11: Tim's new shop progress
12: Fixed this only to realize I can't find the crystal
13: Fixed this only to realize I can't find the crystal
14: Blue on the entire taper - not easy. I can't trust the flats on the lathe.
15: Alsmot finished - just need to cut a flat on it.