(199/325) 2022-10-21_18-46-37.jpg
B&S 1025 This is the new battery- trim-taped to the bottom. The old system had clips that were bent - might have shorted out the circuit board?
198: B&S 1025 thought the switch part was bad - not the type you can solder to - so replaced with tact switches. Still not right.
197: I now have 4 fully restored Millimess - I also have a Supramess - and another one on it's way.
196: Cutting lensplates for old Millimess micrometers. The down-cut bit makes this work great.
195: Angle setup blocks
194: Drill-bit trays Blue is for metric
193: Drill-bit trays Blue is for metric
192: Drill-bit trays Blue is for metric
191: Printing dill trays with PETG-G
190: B&S gauge amp 1025 Header connector for keyboard rows and columns
189: B&S gauge amp 1025 Bad flex circuit strip - Will install tact switches
200: Milling a pair of blocks for calibrating 3d printer.
201: blocks - left and right - syncronize the pair of steppers that control Z. Real important that the bar is parrelle to the build plate for the first layer.
202: Starrett height gage before restore
203: Starrett height gade disassembeled
204: Little Schmoo dispensors.
205: Mitutoyo - Hiator-II - Supramess in disguise.- New lens..
206: Disassembeled Bore gage Standard #3
207: Acetone bottle melted needle - Now using the one Art gave me..
208: Restored Starrett adjustable parallels. Grobet #4 file work on bent corners.
209: Need to make indicator holder so I can test squareness.
