(205/325) 2022-10-25_15-15-49.jpg

Mitutoyo - Hiator-II - Supramess in disguise.- New lens..

204: Little Schmoo dispensors.
203: Starrett height gade disassembeled
202: Starrett height gage before restore
201: blocks - left and right - syncronize the pair of steppers that control Z. Real important that the bar is parrelle to the build plate for the first layer.
200: Milling a pair of blocks for calibrating 3d printer.
199: B&S 1025 This is the new battery- trim-taped to the bottom. The old system had clips that were bent - might have shorted out the circuit board?
198: B&S 1025 thought the switch part was bad - not the type you can solder to - so replaced with tact switches. Still not right.
197: I now have 4 fully restored Millimess - I also have a Supramess - and another one on it's way.
196: Cutting lensplates for old Millimess micrometers. The down-cut bit makes this work great.
195: Angle setup blocks