(189/325) 2022-10-08_19-07-24.jpg
B&S gauge amp 1025 Bad flex circuit strip - Will install tact switches
188: Restored bore gauge
187: Pawnshop find The big one is strange - seems metric - 18mm and 29.5mm Both for $1.
186: Microkator - tests OK
185: Microkator
184: Pulling the jaw assemblies out for cleaning. After they are cleaned - you don't need a puller.
183: Unpaking 4-jawK72 chuck. Full of dirt and grit
182: Unpaking 4-jawK72 chuck. Full of dirt and grit
181: My standard for 220V
180: B&S LVDT head - need docs
179: B&S LVDT head - need docs
190: B&S gauge amp 1025 Header connector for keyboard rows and columns
191: Printing dill trays with PETG-G
192: Drill-bit trays Blue is for metric
193: Drill-bit trays Blue is for metric
194: Drill-bit trays Blue is for metric
195: Angle setup blocks
196: Cutting lensplates for old Millimess micrometers. The down-cut bit makes this work great.
197: I now have 4 fully restored Millimess - I also have a Supramess - and another one on it's way.
198: B&S 1025 thought the switch part was bad - not the type you can solder to - so replaced with tact switches. Still not right.
199: B&S 1025 This is the new battery- trim-taped to the bottom. The old system had clips that were bent - might have shorted out the circuit board?
