(192/364) 2023-05-13_20-42-03.jpg
Profiling the T-nut
191: Art's Gauge plug
190: Art's Gauge plug
189: Art's Gauge plug
188: Art's Gauge plug
187: All cleaned and Treated with boeshield.
186: Shiny stainless M5-0.8
185: I think the anvils on this are too small?
184: Got out the good gauge blocks today.
183: 2023-05-08_16-03-46.jpg
182: Cutting wrench flats
193: Cutting
194: 2023-05-13_21-08-45.jpg
195: Kurt vice on the surface plate - about 10um low on one side.
196: Cutting a flat
197: Final cut on the indicator joint using the 60° cutter Art gave me..<smile>
198: Tapping without a tap holder
199: 2023-05-18_20-41-31.jpg
200: This moves too much?
201: I put the insert number on this mill head with the engraver Art gave me..
202: It has a big chip out of it that wasn't in the picture when I bought it.. I will weld some nickle into it and use the so-grinder to match it up..
