(158/364) 2023-04-22_00-49-16.jpg
The cone end finished
157: Not much room for turning the cone.
156: Making the sleeve for the joint.
155: Super close up of a ding on the milling machine table. You can see the shinny bit the PGS left.
154: Next - need to make knobs.
153: Snugs are finished. Nice positive action.
152: Just need to flip it over and shave off the bottom..
151: 2023-04-14_22-29-38.jpg
150: 2023-04-14_21-52-23.jpg
149: Finally doing the profiling on the indicator stand joint
148: 3d Printed a holder for my Double-taper Y collets.
159: Sleves finished turning. Will drill the cross holes later.
160: A 3D print went very bad..
161: Starting tap
162: 2023-04-23_17-30-49.jpg
163: Sleevs and barrels
164: Sleevs and barrels
165: 2023-04-23_22-49-28.jpg
166: Joint finshed.. I like shallow knurling.. Need a bigger 60° countersink..
167: Level that Danny fished out of the trash for me!
168: Measuring to find the center height.
