(33/364) 2023-01-22_15-17-06.jpg

Had to weld this Stainless back together..

32: Lapping block to brighten it up. Groved iron plate with polycarbonate sheet - 20um diamond paste.
31: 2023-01-18_00-52-40.jpeg
30: Before restoration - A Herman Schmidt/Murkens style Suface-plate-indicator-stand.
29: They don't use sink hangers anymore. They apply silicone caulk/glue and then twist the wires to clamp it into place.
28: Fixing my micrometer that I dropped . Reminder - never drop instruments!
27: Truing up a grinding cup using the tapered arbor I made.
26: Material shelf needs to be reoganized.
25: This worked much better
24: This did not work well - ended up chipping the disk
23: AC4 diamond powder (Venev diamonds) - grain size from 2500 to 40 microns.-- 80-100um or 140-170grit

34: A good ground clamp
35: Trying aluminum foil on groved plate. Does not wear long - too thin.
36: Only 23um [.0009"\
37: lapped down to 2.5um
38: Finished printing the ER40 collet holders.
39: Added RF connector to FM transmitter
40: Connected to RF power amp
41: Tool path.
42: 2023-01-25_20-50-01.jpg
43: Screwed up - cut a bit deep into the aluminum, probably just as well - don't want to cut the 1095 spring-steel with the corner.