(14/325) 2022-04-08_13-37-51.jpg
Sold this - worked well but requires a cell phone that will become obsolete. Will replace with a stand alone unit.
13: Angle grinder - Changed grease - got noisy.
12: Cheap mag base drill overhaul - the counter sinks dimpled the ways - caused it to bind. Ground out the dimples and stoned the ways flat. Chinese equipment should be thought of as a DIY kit.
11: This is a plumers compression ring cutter that is no longer available - Lots of machining steps.
10: This is a plumers compression ring cutter that is no longer available - Lots of machining steps.
9: 2022-03-24_15-33-05.jpg
8: I welded part of the plate back on - mistake - impossible to prevent warping. Should have just made the edge super straight and mounted side-by-side.
7: New bench frame welded up
6: Chip catcher for band saw -
5: Tool holder stand - with milled tapered holes for Kwik-switch 200. Nylon from a cutting board.
4: Tool holder stand - with milled tapered holes for Kwik-switch 200. Nylon from a cutting board.
15: Sold this - worked well but requires a cell phone that will become obsolete. Will replace with a stand alone unit.
16: Sold this - worked well but requires a cell phone that will become obsolete. Will replace with a stand alone unit.
17: Milling sphere to mate with button head screws for bench feet.
18: Milling sphere to mate with button head screws for bench feet.
19: Decking vice anvil..
20: Bench feet - button head with nut locktited on for adjustment.
21: Bench feet - button head with nut locktited on for adjustment.
22: Meger tooling that was to come with the EMCO lathe I decided not to get
23: Meger tooling that was to come with the EMCO lathe I decided not to get
24: Meger tooling that was to come with the EMCO lathe I decided not to get
