(4/325) 2022-01-05_16-01-45.jpg

Tool holder stand - with milled tapered holes for Kwik-switch 200. Nylon from a cutting board.

5: Tool holder stand - with milled tapered holes for Kwik-switch 200. Nylon from a cutting board.
6: Chip catcher for band saw -
7: New bench frame welded up
8: I welded part of the plate back on - mistake - impossible to prevent warping. Should have just made the edge super straight and mounted side-by-side.
9: 2022-03-24_15-33-05.jpg
10: This is a plumers compression ring cutter that is no longer available - Lots of machining steps.
11: This is a plumers compression ring cutter that is no longer available - Lots of machining steps.
12: Cheap mag base drill overhaul - the counter sinks dimpled the ways - caused it to bind. Ground out the dimples and stoned the ways flat. Chinese equipment should be thought of as a DIY kit.
13: Angle grinder - Changed grease - got noisy.
14: Sold this - worked well but requires a cell phone that will become obsolete. Will replace with a stand alone unit.