(32/165) 2025-03-05_15-28-10.jpg
New lube pump
31: New floor of kiln
30: Repairing bottom edge of kiln.
29: Old floor of kiln
28: Making saw table so it can be adjusted square. Holes each side of blade are for allen wrench removal/install.
27: Making saw table so it can be adjusted square. Table square with blade.
26: Making saw table so it can be adjusted square. Bottom plate installed - grub screws sticking up
25: Making saw table so it can be adjusted square. Using block so tap always starts straight.
24: Making saw table so it can be adjusted square.
23: Kiln Repair - teflon sheet to form repair mud.
22: Inside an old lubricator pump.
33: Had to rewire because I put the mounting hole about 25mm to far..
34: Self tightening cresent wrench. Actually works - quite well!
35: Self tightening cresent wrench. Actually works - quite well!
36: Special pliers for removing stripped philips nuts.
37: Super stuby alan wrenches
38: Japanses exacto knife holder that doesn't get loose.
39: Removing old lube system
40: New lube system - drilled tapped.
41: Removing old - mounting replacement is going to need a new plate.. You can see the air in the system - this shows it is back draining when it shouldn't..
42: 1/4" hex wrong size? Why?
