(25/69) 2025-02-23_21-24-40.jpg
Making saw table so it can be adjusted square.
24: Kiln Repair - teflon sheet to form repair mud.
23: Inside an old lubricator pump.
22: Have some porcelain clay to play with
21: Making an adapter for a snap press (sewing) Strange M16-1.0 thread.
20: Making an adapter for a snap press (sewing) Strange M16-1.0 thread.
19: Repainted tool box from 1934. I think this was my grandfathers tackle box originally - but ended up as my first tool box when I was a teenager.
18: This is NTPF (F for Fuel which has no spiral gap) with a copper crush washer. Some stripped hex drives, but can't find new parts. Graco was a waste of time - as are many US companies today.
17: New Crush washers from McMaster
16: Divider valve keeps leaking..
15: 2025-01-16_15-16-02.jpg
26: Making saw table so it can be adjusted square. Using block so tap always starts straight.
27: Making saw table so it can be adjusted square. Bottom plate installed - grub screws sticking up
28: Making saw table so it can be adjusted square. Table square with blade.
29: Making saw table so it can be adjusted square. Holes each side of blade are for allen wrench removal/install.
30: Old floor of kiln
31: Repairing bottom edge of kiln.
32: New floor of kiln
33: New lube pump
34: Had to rewire because I put the mounting hole about 25mm to far..
35: Self tightening cresent wrench. Actually works - quite well!