(291/364) 2023-08-02_01-51-21.jpeg
290: 2023-08-02_01-51-09.jpeg
289: 2023-08-01_17-53-22_1.jpeg
288: 2023-08-01_17-53-22.jpeg
287: 2023-08-01_16-01-21.jpg
286: Got this nice metric Mitutoyo thread mike - had to steel Anvils from an English PAV micrometer that I want to sell..
285: Fixed this with a Chinese M1.6 tip - had to turn a shoulder to extend the thread length.
284: M5 thread mill - Note the tips are rounded. One needs to know the diameter IF the tips came out to a point.
283: Now with brass dowel pins - works fine!
282: Still no joy - the stainless steel dowel pins needed a brazed blob to solder - but the rods make poor contacts. Silver plate or get some brass rods?
281: made a slot in it so I can change the sandpaper with out disassembling everything.
292: 2023-08-02_22-04-40.jpeg
293: 2023-08-02_22-04-40_1.jpeg
294: Not sure why this was pinned - very hard to disassemble
295: needed to make a flate spot
296: Drilled for a dowel pin
297: Now there is something to measure to and a flat for angles. Eventually this might become a useful machine.
298: Trinkets from China
299: Mounted a tray for lathe tool holders.
300: Freecad/path - Threadmill interface
301: 2023-08-10_22-40-56.jpg
