(227/364) 2023-05-29_00-07-16.jpg
This one I can't repair - has a mangled gear
226: This one I can't repair - has a mangled gear
225: New lenses turned out well
224: Cutting setup for lens crystals
223: 2023-05-26_14-47-40.jpg
222: 2023-05-26_14-47-24.jpg
221: Z-axis scale folded into original box.
220: Wells - CPU is in the black box on the right with the monitor hanging on. This has scales on x-y-z operating closed loop and a spindle encoder.
219: Mill control box
218: Finally reassembled.. - Will turn some brass for the cross slide stops tomorrow.
217: Tapping cross slide.
228: I was able to fix 3 out of 5
229: Processed By eBay with ImageMagick, z1.1.0. ||B2
230: Made plastic bumpers - the lathe came with just a bare roll-pin.
231: Moved the vacuum tubes to the novelties shelf - most got knocked and broken
232: Found these - Don't remember where they came from. Tightening the grubscrew spreads the plates.
233: Made an end-stop with a M8 bolt with a ball-bearing pressed into the end.
234: Milling magnet holes
235: Nice flush fit
236: Hangs horizontally!
237: 2023-06-05_17-47-53.jpg
