(143/364) 2023-04-11_17-00-50.jpg
Boring failed as the hole got larger
142: Tried to bore to size.
141: Not a good setup.. Learned a lesson here.
140: Art's indicator stand with 1" hollow colum.
139: Art's indicator stand with 1" hollow colum.
138: Art's indicator stand with 1" hollow colum.
137: Art's indicator stand with 1" hollow colum.
136: Art's indicator stand with 1" hollow colum.
135: Art's indicator stand with 1" hollow colum.
134: Art's indicator stand with 1" hollow colum.
133: Art's indicator stand with 1" hollow colum.
144: Ended up using just a drill bit.
145: Snubs turned out well.
146: Printing MT3 din-rail holder for the lathe.
147: Dereeling set up for the wire-cut/strip machine. I use a torid inductor as a damping weight - then the wire goes over a spool the is supported by elastic cords. The motion of the wire is jerky - would jam or tangle - this works.
148: 3d Printed a holder for my Double-taper Y collets.
149: Finally doing the profiling on the indicator stand joint
150: 2023-04-14_21-52-23.jpg
151: 2023-04-14_22-29-38.jpg
152: Just need to flip it over and shave off the bottom..
153: Snugs are finished. Nice positive action.
