(276/325) 2022-11-22_14-22-35.jpg

Gap in carriage clamp when fully tightened.

275: Art says he is going to send this to me - can't wait!
274: Art says he is going to send this to me - can't wait!
273: Art says he is going to send this to me - can't wait!
272: Art sent me this on the bench micrometer I restored.
271: Brass tipped grub scews for tail-stock. You can also see the slot I cut in the brass shaft.
270: hanging the scale mount - jack screws to set angles.
269: hanging the scale mount - jack screws to set angles.
268: Milled a flat for the adjusters to push on - and cleaned up the cross-surfaces.
267: Rough adjust tail stock -- not working right.
266: This is the 10" face-plate they sent me! Foundry sand surface. You have to be kidding? I would expect better out of China.

277: Adaptive milling block to mount lathe scale.
278: Top of carriage level -- but ..
279: does not match ways.
280: disassembling to clean
281: Bottom of lathe sadle - came full of grit.
282: Grit on oilers
283: Inking shows really poor contact.
284: Replacement faceplate has paint on the taper.
285: Under paint - taper did not clean up.
286: lining up saddle