(258/325) 2022-11-08_17-42-58.jpg

I think I will add a jack screw to the block on the right.

257: Packed with grease mixed with metal bits..
256: More to clean.
255: Gib direction
254: Scraped dovetails? or just decoration?
253: 2022-11-08_14-19-37.jpg
252: Comes complete with free metal shavings
251: Possible design for checking perpendicularity.
250: notice the white paint on the gears..
249: Ground it out so it has a chance to work.
248: This hole was for sliding a tube in to fill the drip gallery with oil - not a straight shot.

259: Every thing is full of grit.
260: Picking up the lathe. The motor lift helps with balencing.
261: Getting closer. Put loctite 'make-a-gasket' on top of the stands and under the lathe.
262: Not cleaned up.. will have to mill it.
263: Used my Russian straight edge.
264: Cleaning up the top of the tailstock. Indicated true with the plunger.
265: Cleaned up the rough edge (3 pictures back).
266: This is the 10" face-plate they sent me! Foundry sand surface. You have to be kidding? I would expect better out of China.
267: Rough adjust tail stock -- not working right.
268: Milled a flat for the adjusters to push on - and cleaned up the cross-surfaces.