(226/325) 2022-11-02_13-11-16.jpg
Broke clean through on this side.
225: Lathe arrived with a broken bottom skid.
224: 2022-11-01_14-33-24.jpg
223: 2022-11-01_14-33-13.jpg
222: 2022-11-01_14-26-41.jpg
221: 2022-10-30_18-10-07.jpg
220: 2022-10-30_18-08-54.jpg
219: 2022-10-30_18-08-24.jpg
218: 2022-10-30_18-08-15.jpg
217: 2022-10-29_12-37-34.jpg
216: Rightangle gauge idea
227: Hard to see - had to put a furnature dolly on the end - what a mess.
228: The steep hill went fine - if it started to roll - I just set it down. Getting in the door took an hour - the ground is so dry - there was a 13mm jump that the dolly would stick on..
229: Crate not in great shape.
230: Lots of cleaning work.
231: Saved the crate box for now.
232: Lots to unpack and assemble.
233: Just a rough cast dimple - so I made a good surface... To be continued..
234: Dipped a magnet in the oil tank of the new lathe. Full of metal shavings.
235: Cleaned the 3-jaw that came with the lathe- had a full table-spoon of sand and metal grit.
236: Cleaned the 3-jaw that came with the lathe- had a full table-spoon of sand and metal grit.
