(220/325) 2022-10-30_18-08-54.jpg
219: 2022-10-30_18-08-24.jpg
218: 2022-10-30_18-08-15.jpg
217: 2022-10-29_12-37-34.jpg
216: Rightangle gauge idea
215: Full disassembly
214: 2022-10-27_16-31-19.jpg
213: Made apin wrench to disassemble Marh snap gauge.
212: drilling 1.4mm hole with peck cycle
211: Calibrating the veniers
210: lots of schmoo!
221: 2022-10-30_18-10-07.jpg
222: 2022-11-01_14-26-41.jpg
223: 2022-11-01_14-33-13.jpg
224: 2022-11-01_14-33-24.jpg
225: Lathe arrived with a broken bottom skid.
226: Broke clean through on this side.
227: Hard to see - had to put a furnature dolly on the end - what a mess.
228: The steep hill went fine - if it started to roll - I just set it down. Getting in the door took an hour - the ground is so dry - there was a 13mm jump that the dolly would stick on..
229: Crate not in great shape.
230: Lots of cleaning work.
