(70/325) 2022-05-26_10-35-02.jpg
Very strange infection/bruise ??
69: Pair of holes on the front edge were for pins. Dates back when they used iron surface plates and there was a ground front edge that the pins could align to.
68: mm engraved and inked - inking takes multiple coats of ink-stick.
67: milimess 1um with release
66: Computer case with SLOW and quite fan.
65: Making loc-line attachment for lamp
64: Making loc-line attachment for lamp
63: 1/2" loc-line for gooseneck light and vacuum.
62: Modifying D-bit - Deckel style grinder.. Vaccum is manditory - lots of open parts that get coated in grit.. Need to clean befor moving and adjustment.
61: Open tubes of RTV(silicone caulk) won't plug up if stored with a desicant (blue stuff on the bottom).
60: I made a wheel tool for the D-bit Deckel style grinder.
71: Lots of joints in Deckle style SO D-bit grinders.
72: Mitutoyo indicator - missing screw.
73: Mitutoyo indicator - Plastic lens? Cracked in two places..
74: Restoring Mahr bench mic with Supramess Original state
75: Restoring Mahr bench mic with Supramess Touch of rust
76: Restoring Mahr bench mic with Supramess Supramess - sort of the ultimate in mechanical indicators.
77: Restoring Mahr bench mic with Supramess Stripping the casting let me see shaped snugs. This was well made - no short cuts.
78: Restoring Mahr bench mic with Supramess Didn't have a 3mm wrench - made some snugs to free some small frozen parts - pliers would have ruined everything.
79: Restoring Mahr bench mic with Supramess, This retractor suprized me with a sping. The anvil fits with a taper.
80: Restoring Mahr bench mic with Supramess Disassembly of the thimble - had to clean a bit of rust in the locking system. Needed cleaning.
