(16/27) 2026-02-20_13-59-46.jpg
Nightmare job - Steel pegs in aluminum - electro--welded due to water in frame.
15: Portrait of Jamie by Hockney
14: 2026-02-13_14-09-50.jpeg
13: Buds opening early
12: 2026-02-09_16-13-30.jpg
11: 8" Sewer reline - sleave - Steam heat fires the embedded resin.
10: 8" Sewer reline - sleave - Steam heat fires the embedded resin.
9: 8" Sewer reline - sleave - Steam heat fires the embedded resin.
8: 8" Sewer reline - sleave - Steam heat fires the embedded resin.
7: 8" Sewer reline - sleave - Steam heat fires the embedded resin.
6: 8" Sewer reline - sleave - Steam heat fires the embedded resin.
17: Chuck spun on MT2
18: Early Fruit flowers - will they drop on a freeze?
19: Tulips are up
20: 3D printing night mare - turns out that the Z offsets changes the config.. Does auto-leveling off not follow the off setts? Why would you adjust at 0.1mm at a time?
21: Stripped thread on 3D printer head - they used the thin wall - I redid it with the thick wall and a longer grub-screw.
22: Chuck spun on arbor
23: Chuck spun on arbor
24: This Cushman is good
25: Spalling was on the outer limit - I just turned a big chamfer to get rid of the bad part.
26: The 3D gods are fighting me. Print nozzle was leaking- over tightened - swapped for a differnt hot block, new hot block had shorted thermistor - wire for the thermistor cable broke.
