(177/235) 2025-07-12_20-37-18.jpg
Federal 230 gage heads - Bench has aquired a maze like attitude.
176: Federal 230 gage heads. Test set up blocks so I can go up and down 0.3mm
175: Federal 230 gage heads
174: Federal 230 gage heads. This pot has both course and fine adjust!
173: Federal 230 gage heads - wonder if I can find sockets for this power connector?
172: Federal 230 gage heads. This one is later and has coupling caps.
171: Federal 230 gage heads - Two of this very old variant - no schematic and no coupling caps. Will use for parts.
170: Federal 230 gage heads - washer stack setup.
169: Federal 230 gage heads
168: Documenting my Tig button controller
167: Documenting my Tig button controller
178: Federal 230 gage heads
179: This will be the table top for the fume hood.
180: Vent that will extract for the fume hood.
181: Federal 230 gage heads. Two 18650s should make a nice update for the power.
182: My painter friend Troy says this is a good primer..
183: Powder coating
184: Spline shaft project
185: 1uF cap identification
186: Federal 230 electronics and project
187: Federal 230 - the tiny breadboard added is a voltage regulator so it works with the new batteries.
