(167/235) 2025-06-20_17-39-39.jpg
Documenting my Tig button controller
166: I've been collecting some glass ware for doing some chemisty work.
165: I've been collecting some glass ware for doing some chemisty work.
164: Printed this vacuum aspirator - didn't really work.. To small a hole.
163: Tim's recording studio progress - special windows.
162: Tim's recording studio progress - sloping roof - walls should not be parrallel?
161: Tim's recording studio progress - floor is complicated.
160: Replacing oil - slow sphon.
159: Changing oil in lathe - break-in is over - the magnets I put in the oil path did their job - big one on the bottom of the tank as well.
158: 2025-06-02_16-33-33.jpg
157: 2025-06-02_16-29-02.jpg
168: Documenting my Tig button controller
169: Federal 230 gage heads
170: Federal 230 gage heads - washer stack setup.
171: Federal 230 gage heads - Two of this very old variant - no schematic and no coupling caps. Will use for parts.
172: Federal 230 gage heads. This one is later and has coupling caps.
173: Federal 230 gage heads - wonder if I can find sockets for this power connector?
174: Federal 230 gage heads. This pot has both course and fine adjust!
175: Federal 230 gage heads
176: Federal 230 gage heads. Test set up blocks so I can go up and down 0.3mm
177: Federal 230 gage heads - Bench has aquired a maze like attitude.
