(150/235) 2025-05-21_20-51-57.jpg
Boring out to press on to the ER32 shaft
149: C5 collett to ER32 conversion - made a ring to match the old
148: Thread cutting M30-1.0
147: Some lathe work
146: Disassembly of D-bit grinder
145: Disassembly of D-bit grinder
144: 2025-05-18_22-16-53.jpg
143: C5 collets are size limited
142: Now that it is sharp, it makes cleaner cuts - less rolling over of the leads.
141: D-bit grinder works well for this.
140: Setting up to sharpen the lead-trim carbide blade.
151: C5 collett to ER32 conversion - made a ring to match the old
152: Doggy set up to mill key-slop
153: 2025-05-27_18-39-09.jpg
154: Threaded sleeve pressed on to match C5. It expanded the sleeve enough had to take off a bit.. PITA
155: 2025-05-28_21-23-43.jpg
156: 2025-05-31_11-59-34.jpg
157: 2025-06-02_16-29-02.jpg
158: 2025-06-02_16-33-33.jpg
159: Changing oil in lathe - break-in is over - the magnets I put in the oil path did their job - big one on the bottom of the tank as well.
160: Replacing oil - slow sphon.
