(137/235) 2025-05-15_21-36-51.jpg
Adjusting the flat so it is perfectly level - attempting to drill the probe stud out -
136: I need to wait for the M3.5 nuts to lock the alluminum screw feet to fully test.
135: This is the 254TPI (0,1mm pitch) micro adjuster.
134: With just a point, I can find deviations in the surface plate.
133: Made a better diffuser
132: new Powder coating gun
131: This is the setup I used to drill indicator
130: Indicator side opened
129: Failed contact in Washing machine
128: Washing machine repair
127: Trouble drilling - so had to disassemble the indicator
138: This is the indicator, has no model number - just a serial number that they can't cross reference. Strange.
139: 2025-05-16_16-50-58.jpg
140: Setting up to sharpen the lead-trim carbide blade.
141: D-bit grinder works well for this.
142: Now that it is sharp, it makes cleaner cuts - less rolling over of the leads.
143: C5 collets are size limited
144: 2025-05-18_22-16-53.jpg
145: Disassembly of D-bit grinder
146: Disassembly of D-bit grinder
147: Some lathe work
