(127/235) 2025-05-05_17-17-04.jpg
Trouble drilling - so had to disassemble the indicator
126: Left hand drill -
125: Using centering scope to line up the mill
124: Not much surface to align with.
123: Trying to drill out old broken off probe
122: Drilling grub-screw hole
121: Norma's Irises in bloom.
120: Everything but the grub-screw hole tapped
119: Cutting copper for jaws for a vise.
118: Just need a hole for a grub-screw
117: Split it
128: Washing machine repair
129: Failed contact in Washing machine
130: Indicator side opened
131: This is the setup I used to drill indicator
132: new Powder coating gun
133: Made a better diffuser
134: With just a point, I can find deviations in the surface plate.
135: This is the 254TPI (0,1mm pitch) micro adjuster.
136: I need to wait for the M3.5 nuts to lock the alluminum screw feet to fully test.
137: Adjusting the flat so it is perfectly level - attempting to drill the probe stud out -
