(104/235) 2025-04-17_16-56-14.jpg
I ground the endmill so it had a chamfer.
103: He said 0.1mm step down - seems he might have meant 1mm?
102: Routing out the sperometer plate - using Stephans recipe.
101: Weaping hydrant.. got a rebuild kit - but the packing nut seems like a loose fit?
100: Got the Microcode II back together with the new switch - everything works.
99: Tim's plane seriously needs a bath.
98: I used 100% nickle rod for the first time thinking it was cast iron - not sure - might have been wrought steel. Easy to weld with.
97: Repaired C-clamp - looked like there was a defect in the original casting? Lower left.
96: Could be time to clean my bench?
95: I seem to have an indicator addiction.
94: Starrett Bench micrometer/ indicator calibrator - Art's.
105: I ground the endmill so it had a chamfer.
106: I ground the endmill so it had a chamfer.
107: Something is wrong? I checked and checked - I think it was the beta software.
108: Something is wrong? I checked and checked - I think it was the beta software.
109: Treasures from Art - X-mas in April!
110: Treasures from Art - X-mas in April! Mystery item - figured it out - someone worked VERY hard to make this - electric contact for micrometer head.
111: Treasures from Art - X-mas in April! Will be the stand for the Bench mike I'm making.
112: So They used a CMOS buffer so there was zero current flowing through the micrometer threads.
113: So They used a CMOS buffer so there was zero current flowing through the micrometer threads.
114: Lots of work - I think shop made?
