(98/235) 2025-04-06_20-20-19.jpg
I used 100% nickle rod for the first time thinking it was cast iron - not sure - might have been wrought steel. Easy to weld with.
97: Repaired C-clamp - looked like there was a defect in the original casting? Lower left.
96: Could be time to clean my bench?
95: I seem to have an indicator addiction.
94: Starrett Bench micrometer/ indicator calibrator - Art's.
93: Starrett Bench micrometer/ indicator calibrator - Art's.
92: Mahr bench micrometer.
91: Switch broken off - was able to locate a new one.
90: didn't have replacemnt for broken switch - ordered.
89: cleaned up well with acetone. Reads out sub micron
88: Thread and every thing had brown stuff that wasn't rust.
99: Tim's plane seriously needs a bath.
100: Got the Microcode II back together with the new switch - everything works.
101: Weaping hydrant.. got a rebuild kit - but the packing nut seems like a loose fit?
102: Routing out the sperometer plate - using Stephans recipe.
103: He said 0.1mm step down - seems he might have meant 1mm?
104: I ground the endmill so it had a chamfer.
105: I ground the endmill so it had a chamfer.
106: I ground the endmill so it had a chamfer.
107: Something is wrong? I checked and checked - I think it was the beta software.
108: Something is wrong? I checked and checked - I think it was the beta software.
