(64/235) 2025-03-18_22-10-16.jpg
Nice center closing vise.
63: lube-pump disassembled.
62: Lube-pump Piston end.
61: Kiln reassembled and the mortar fired - the grey turns to light pink.
60: Ground down a deditcated wrench for the pencil air grinder.
59: Ground down a deditcated wrench for the pencil air grinder.
58: Ground down a deditcated wrench for the pencil air grinder.
57: Assembling the lube meters stack.
56: Assembling the lube meters stack
55: Assembling the lube meters stack
54: Assembling the lube meters stack
65: Nice center closing vise.
66: Nice center closing vise. Pins for mounting it.
67: Scketchy setup - These grinding disks aren't made with the 1.25" hole.
68: Scketchy setup - These grinding disks aren't made with the 1.25" hole.
69: Tiny soldering iron with computerized controls
70: Just a hair to small so I had to bore out 21 and 22mm
71: Just a hair to small so I had to bore out 21 and 22mm. Used a bit of spray and wipe for coolant.
72: First time I used this asian boring head - mounted on a kwik-switch-200. Works well. Not a Wohlhaupter, but works.
73: Color coded my sockets.
74: Never though I would use this mag base as much as I do.
