(244/325) 2022-11-05_20-52-23.jpg
New Precision Mathews lathe PM-1236T-1
243: New Precision Mathews lathe PM-1236T-1 Flushing the grit out.
242: New Precision Mathews lathe PM-1236T-1 Set -up to drain back to the parts cleaner
241: New Precision Mathews lathe PM-1236T-1 Rigged up my parts cleaning tank to flush out the headstock - new filter.
240: New Precision Mathews lathe PM-1236T-1
239: New Precision Mathews lathe PM-1236T-1 You can see the grit sitting in the oil grove at the top of the headstock.
238: 2022-11-05_14-13-42.jpg
237: 2022-11-05_14-13-02.jpg
236: Cleaned the 3-jaw that came with the lathe- had a full table-spoon of sand and metal grit.
235: Cleaned the 3-jaw that came with the lathe- had a full table-spoon of sand and metal grit.
234: Dipped a magnet in the oil tank of the new lathe. Full of metal shavings.
245: New Precision Mathews lathe PM-1236T-1 You can see shinny metal flakes at the bottom - already flushe some.
246: Clean up finished on this end. The copper is for draining oil next time.
247: Gears full of grit - packed with wax - paint on gears - long clean up.
248: This hole was for sliding a tube in to fill the drip gallery with oil - not a straight shot.
249: Ground it out so it has a chance to work.
250: notice the white paint on the gears..
251: Possible design for checking perpendicularity.
252: Comes complete with free metal shavings
253: 2022-11-08_14-19-37.jpg
254: Scraped dovetails? or just decoration?
