(138/325) 2022-07-15_16-46-57.jpg
3D print magnet holder Printing on mirror tile (Cheap glass)..
137: 3D print magnet holder
136: Mill table surface - closeup The shiny part is true - but there is black stuff in the bottom of the pits that won't clean out.
135: DIY Spring steel screwdiver
134: DIY Spring steel screwdiver
133: making shelf skates
132: Down cut carbide router bit.
131: What is missing in descriptions is that the twists HAVE to be in opposite directions. Bell crank not needed? Why is the shaft so huge? I should make a mirror with LASER pointer version.. Hard part - calibrating..
130: Caliper repair Test -- Cheap but appears good to 10um.
129: Caliper repair everything Blown off with clean dry shop air.
128: Caliper repair Cleaned with flux remover.
139: Scrap gold - sold off instead of messing with chemicals.
140: UPS project - LiFePo4 battery balancers - waiting for the rest to arrive.
141: Cutting dead tree down Gash to aim
142: Cutting dead tree down Ready to fall
143: Cutting dead tree down Timber!
144: Cutting dead tree down Pretty good sized job for an old fart.
145: Cutting dead tree down Ran out of steam..
146: Setuo for drillin off-center hole in end of rod.
147: Bad drill bit - brand new - 7.5mm but cuts at over 8mm.
148: Vanessa found a Durian sign
